6 Steps to Flooring Acclimation Success

Acclimation, otherwise called conditioning, is the process of allowing wood to reach its equilibrium moisture content (EMC) within “normal living conditions.” It is also one of the most important steps for the hardwood flooring installation process. Not properly acclimating or conditioning wood flooring may cause excessive expansion, shrinkage, distortion, or structural damage. Before installing any hardwood floors, check with the manufacturer on the proper acclamation process of the material. 

If the flooring material being installed does not have specific acclimation and conditioning instructions, here are the steps to follow:

Step 1: Make sure that the heating and air conditioning units are in operation at least five days before delivery of the flooring. Make sure to keep an eye on the AC or heating unit during installation and also after the flooring is installed. If it is not possible for a permanent HVAC to be operating before, during and after installation, a temporary system that mimics normal living conditions may enable installation to proceed. Check out our article on Moisture Management Control for more information on how to mimic normal living conditions for acclimation. 

Step 2: Once the facility has been confirmed to be at normal living conditions, proceed with the delivery of flooring material. Check the moisture content of the wood flooring as soon as it is received.

Step 3: Check the moisture content of the subfloor. The moisture content of the subfloor should coincide with the temperature and relative humidity of the jobsite, based on the temperature, relative humidity and average moisture content chart shown below. This moisture content reading will give you a good idea of where the conditions in the facility are being maintained and allow you to compare to the expected “in-use” conditions.

tile contractors orlando fl.jpeg

Step 4: Ensure the flooring material is exposed to the “normal” conditions of the environment in which it is being installed. To accomplish this, break the flooring units into small lots and/or open the flooring packages. Start stacking elevated from the subfloor. Acclimate to equilibrium moisture content for as long as it takes. Some species of hardwood flooring will take much longer to reach equilibrium moisture content than others. It is never a good idea to base acclimation on time alone, but rather on actual moisture content. Check with the manufacturer before beginning this stage, in case they have different acclimation instructions.

Step 5: If the flooring material cannot be delivered to an adequate jobsite, pre-acclimate the material in an off-site location set to mimic the expected conditions of the jobsite. Then deliver pre-acclimated material to the jobsite once “normal conditions” can be established. Again, refer to the temperature, relative humidity and moisture content chart to determine ideal conditions.

Step 6: Finally, make sure the flooring and wood subfloor moisture content is within the acceptable range for the jobsite. The subfloor should be within 4 percent for strip and 2 percent for plank wood flooring.

Wood is only acclimated once it reaches its EMC for the space in which it is expected to be installed. Equilibrium moisture content is based on an “unchanging” environment. After a wood floor has been installed, changing conditions within the environment will change the equilibrium moisture content of the wood floor, ultimately resulting in dimensional change.